Pinpoint Test A: DTC B2103 - Antenna Not Connected
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- A1 INSPECT THE PATS TRANSCEIVER FOR CORRECT INSTALLATION NOTE: Replacement of the PATS transceiver does not require the PATS keys to be programmed into the instrument cluster (IC) again.
- Key in OFF position.
- Verify the PATS transceiver is correctly installed. Refer to Passive Anti-Theft System (PATS) Transceiver .
- Connect the diagnostic tool.
- Key in ON position.
- Enter the following diagnostic mode on the diagnostic tool: Clear the DTCs
- Key in OFF position.
- Key in ON position.
- Enter the following diagnostic mode on the diagnostic tool: Retrieve the DTCs
- Is DTC B2103 or B1232 retrieved?
- YES : INSTALL a new PATS transceiver. REFER to Passive Anti-Theft System (PATS) Transceiver . CLEAR the DTCs. CYCLE the ignition. REPEAT the self-test. TEST the system for normal operation.
- NO : The system is OK.