LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1012 (Exterior Lighting System) >> Removal And Installation >> Stoplamp Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not service the brake pedal, brake booster, or master cylinder without first removing the stoplamp switch. Do not install the stoplamp switch without the brake pedal arm secured to the brake booster push rod. Do not press or pull on brake pedal when installing or removing the stoplamp switch otherwise misadjustment or damage to the stoplamp switch could occur.
    NOTE: Rotate the stoplamp switch clockwise approximately 1/8 turn to remove.
  1. Remove the stoplamp switch.
    • Disconnect the electrical connector.
  2. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals