LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1008 (Exterior Trim And Ornamentation) >> Removal And Installation >> Window Molding - Front Door >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door glass run. For additional information, refer to GLASS, FRAMES AND MECHANISMS article.
  2. Drill out the window molding rivets.
  3. Remove the window molding.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals