Removal And Installation

All vehicles 

1. Position the front seats forward and remove the 2 floor console rear bolts.
2. Position the front seats rearward.
3. If equipped, pull the parking brake handle upward.

Fusion, Milan 

4. If equipped with an automatic transmission, remove the selector lever trim ring.

All vehicles 

5. If equipped with a manual transmission, remove the gearshift knob.
6. Open the storage compartment door.
7. Remove the floor console finish panel.
   • Disconnect the electrical connectors.

Fusion, Milan 

8. Remove the utility tray.
   • Disconnect the electrical connector.
   • Disconnect the audio jack connector.
9. Remove the 2 floor console bolt covers.
10. Remove the 2 floor console bolts.

MKZ only 

11. Remove the LH and RH floor console trim panels.
Fig 1: Identifying Console Side Finish Panels
Courtesy of FORD MOTOR CO.
12. Remove the 2 floor console-to-instrument panel bolts (one each side).
Fig 2: Identifying Console-To-Instrument Panel Bolts
Courtesy of FORD MOTOR CO.

All vehicles 

13. Remove the 4 floor console bolts and remove the floor console.
14. To install, reverse the removal procedure.