Instrument Cluster (IC): Removal

All vehicles 

1. If installing a new instrument cluster (IC), upload the module configuration to the scan tool. For additional information, refer to MODULE CONFIGURATION article, programmable module installation (PMI).
2. Tilt the steering column to the lowest position.

MKZ 

3. Remove the 2 instrument cluster (IC) finish panel screws and the instrument cluster (IC) finish panel.
4. Remove the 2 screws and the instrument cluster (IC).
   • Disconnect the electrical connector.

Fusion, Milan 

NOTE: The instrument cluster (IC) finish panel is held in place by spring clips located on the finish panel.
5. Remove the instrument cluster (IC) finish panel.
NOTE: The top of the instrument cluster (IC) is a snap fit to the instrument panel. To ease removal of the instrument cluster (IC) insert a suitable tool between the instrument panel and the top of the instrument cluster (IC) and use a slight outward movement until the top of the instrument cluster (IC) is released. The instrument cluster (IC) can now be rotated outwards.
6. Remove the 2 screws and the instrument cluster (IC).
   • Disconnect the electrical connector.