Spark Plugs: Removal

RH side 

NOTE: The upper intake manifold must be removed to access the RH spark plugs only.
1. Remove the upper intake manifold. For additional information, refer to ENGINE - 3.0L (4V) article.

Both sides 

2. Disconnect the 6 ignition coil-on-plug electrical connectors.
NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
3. Remove the 6 bolts and the 6 ignition coil-on-plugs.
NOTE: Only use hand tools when removing or installing the spark plugs, or damage can occur to the cylinder head or spark plug.
NOTE: Use compressed air to remove any foreign material in the spark plug well before removing the spark plugs.
4. Remove the 6 spark plugs.