LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine - 3.0L (4V)) >> In-Vehicle Servicing >> Valve Spring, Retainer, and Seal >> Installation

Valve Spring, Retainer, and Seal: Installation

WARNING: This page is about a different variant/trim than selected.
    NOTE: Lubricate the valve guide with clean engine oil.
  1. Using the Valve Stem Oil Seal Installer, install the new valve seal.
    2. Fig 1: Installing Valve Seal
    GF0017057Courtesy of FORD MOTOR CO.
    NOTE: If the components are to be reinstalled, they must be installed in their original positions or damage to the engine may occur.
  2. Using the Valve Spring Compressor, install the valve spring, retainer and key.
    3. Fig 2: Identifying Special Tool (303-473)
    G03898348Courtesy of FORD MOTOR CO.
  3. Install the camshaft roller followers. For additional information, refer to Camshaft Roller Follower .
scientia non olet · About LEMON Manuals