LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine - 3.0L (4V)) >> In-Vehicle Servicing >> Upper Intake Manifold >> Removal

Upper Intake Manifold: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING - 3.0L (4V) article.
  2. Disconnect the Throttle Body (TB) electrical connector.
  3. Remove the 4 bolts and position the TB aside.
    • Discard the gasket.
  4. Disconnect the Evaporative Emission (EVAP) tube from the intake manifold.
  5. Remove the vacuum tube clamp bolt.
  6. Disconnect the vacuum tube from the intake manifold.
  7. Disconnect the PCV tube from the intake manifold.
  8. Disconnect the EGR valve electrical connector.
  9. Loosen the EGR tube-to-EGR valve nut.
  10. Disconnect the Manifold Absolute Pressure (MAP) sensor electrical connector and the pin-type retainer.
  11. Detach the wiring harness retainer from the front of the upper intake manifold.
  12. Remove the 8 bolts and remove the upper intake manifold.
    • Remove and discard the gaskets.
scientia non olet · About LEMON Manuals