LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine - 3.0L (4V)) >> In-Vehicle Servicing >> Upper Intake Manifold >> Installation

Upper Intake Manifold: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Clean and inspect all of the sealing surfaces of the upper intake manifold.
    2. NOTE: Install new upper intake manifold gaskets.
  2. Install the upper intake manifold, gaskets and the 8 bolts.
    • Tighten in the sequence shown to 10 Nm (89 lb-in).
    3. Fig 1: Identifying Tightening Sequence Of Upper Intake Manifold Bolts
    GF0028866Courtesy of FORD MOTOR CO.
  3. Attach the wiring harness retainer to the front of the upper intake manifold.
  4. Connect the MAP sensor electrical connector and the pin-type retainer.
  5. Install the EGR tube-to-EGR valve nut.
    • Tighten to 40 Nm (30 lb-ft).
  6. Connect the EGR valve electrical connector.
  7. Connect the PCV tube to the intake manifold.
  8. Connect the vacuum tube to the intake manifold.
  9. Install the vacuum tube clamp bolt.
    • Tighten to 10 Nm (89 lb-in).
  10. Connect the EVAP tube to the intake manifold.
    11. NOTE: Install a new TB gasket.
  11. Install the gasket, TB and 4 bolts.
    • Tighten to 10 Nm (89 lb-in).
  12. Connect the TB electrical connector.
  13. Install the air cleaner outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING - 3.0L (4V) article.
scientia non olet · About LEMON Manuals