LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine - 3.0L (4V)) >> In-Vehicle Servicing >> Oil Pump >> Removal

Oil Pump: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the timing drive components. For additional information, refer to Timing Drive Components .
  3. Remove the oil pump screen and pickup tube. For additional information, refer to Oil Pump Screen and Pickup Tube .
  4. Remove the 4 bolts in the sequence shown.
    5. Fig 1: Identifying Removing Sequence Of Oil Pump Bolts
    GF0017070Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals