LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine - 3.0L (4V)) >> In-Vehicle Servicing >> Oil Pump Screen and Pickup Tube >> Removal

Oil Pump Screen and Pickup Tube: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the oil pan. For additional information, refer to Oil Pan .
  3. Remove the 2 bolts and the oil pump screen and pickup tube.
    • Remove and discard the O-ring seal.
    4. Fig 1: Locating Oil Pump Screen & Pickup Tube Bolts
    GF0017179Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals