LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine - 3.0L (4V)) >> In-Vehicle Servicing >> Oil Pump Screen and Pickup Tube >> Installation

Oil Pump Screen and Pickup Tube: Installation

WARNING: This page is about a different variant/trim than selected.
    NOTE: Lubricate the O-ring seal with clean engine oil.
  1. Install a new O-ring seal on the oil pump screen and pickup tube.
  2. Install the oil pump screen and pickup tube and the 2 bolts.
    • Tighten to 10 Nm (89 lb-in).
    3. Fig 1: Locating Oil Pump Screen & Pickup Tube Bolts
    GF0017179Courtesy of FORD MOTOR CO.
  3. Install the oil pan. For additional information, refer to Oil Pan .
scientia non olet · About LEMON Manuals