LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine - 3.0L (4V)) >> In-Vehicle Servicing >> Oil Pan >> Removal

Oil Pan: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the LH catalytic converter. For additional information, refer to EXHAUST SYSTEM article.
  3. Drain the engine oil and install the drain plug.
    • Tighten to 26 Nm (19 lb-ft).
  4. Remove the 2 oil pan-to-transaxle bolts.
    5. NOTE: For reference during installation, mark the location of the stud bolts.
  5. Remove the 10 bolts, 5 stud bolts and the oil pan.
    • Discard the gasket.
scientia non olet · About LEMON Manuals