LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine - 3.0L (4V)) >> In-Vehicle Servicing >> Lower Intake Manifold >> Installation

Lower Intake Manifold: Installation

WARNING: This page is about a different variant/trim than selected.
    NOTE: Clean and inspect all sealing surfaces.
  1. Using new gaskets, install the lower intake manifold and the 8 bolts.
    • Tighten in the sequence shown to 10 Nm (89 lb-in).
    2. Fig 1: Identifying Tightening Sequence Of Lower Intake Manifold Bolts
    GF0028868Courtesy of FORD MOTOR CO.
  2. Connect the 6 fuel injector electrical connectors.
  3. Attach the 3 pin-type retainers to the fuel rail.
  4. Attach the 2 wiring harness retainers to the RH and LH valve cover stud bolts.
  5. Connect the fuel supply tube quick connect coupling at the fuel rail. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.
  6. Install the upper intake manifold. For additional information, refer to Upper Intake Manifold .
  7. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
scientia non olet · About LEMON Manuals