LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine - 3.0L (4V)) >> In-Vehicle Servicing >> Flexplate >> Removal And Installation

Removal And Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the transaxle. For additional information, refer to AUTOMATIC TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS .
    3. NOTE: One of the 8 flexplate holes are offset so the flexplate can only be installed in one position.
  3. Remove the bolts and the flexplate.
    • To install, tighten to 80 Nm (59 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals