LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine - 3.0L (4V)) >> In-Vehicle Servicing >> Crankshaft Pulley >> Removal

Crankshaft Pulley: Removal

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE - 3.0L (4V) article.
  3. Use the Strap Wrench to hold the crankshaft pulley and remove the crankshaft pulley bolt and washer.
    4. Fig 1: Identifying Special Tool (303-D055) And Crankshaft Pulley Bolts
    GF0024221Courtesy of FORD MOTOR CO.
  4. Using the 3-Jaw Puller, remove the crankshaft pulley.
    5. Fig 2: Identifying Special Tools (303-D121) And Crankshaft Pulley
    GF0017017Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals