LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transaxle/Transmission - AISIN Aw21) >> Disassembly And Assembly Of Subassemblies >> Torque Converter Hub Seal >> Disassembly

Torque Converter Hub Seal: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transaxle. For additional information, refer to Transaxle - 3.0L  or Transaxle - 3.5L .
  2. Remove the torque converter.
  3. Using the Input Shaft Oil Seal Remover and Slide Hammer, remove the torque converter hub seal.
    4. Fig 1: Removing Torque Converter Hub Seal
    GF0017795Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals