LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transaxle/Transmission - AISIN Aw21) >> Disassembly And Assembly Of Subassemblies >> Torque Converter Hub Seal >> Assembly

Torque Converter Hub Seal: Assembly

WARNING: This page is about a different variant/trim than selected.
  1. Position the torque converter hub seal in place.
    2. Fig 1: Positioning Torque Converter Hub Seal In Place
    GF0017796Courtesy of FORD MOTOR CO.
  2. Using the Converter Seal Installer, install the torque converter hub seal.
    3. Fig 2: Installing Torque Converter Hub Seal
    GF0017797Courtesy of FORD MOTOR CO.
  3. Install the torque converter.
  4. Install the transaxle. For additional information, refer to Transaxle - 3.0L  or Transaxle - 3.5L .
scientia non olet · About LEMON Manuals