Pinpoint Tests - Non OSC Equipped Vehicle: Notes

Illustration	Tool Name	Tool Number
	73 III Automotive Meter	105-R0057 or equivalent
	Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool

Anytime an electrical connector or solenoid body is disconnected, inspect the connector for pin condition, corrosion and contamination. Also inspect the connector seal for damage. Clean, repair or install a new connector as required.

Prior to carrying out the pinpoint tests, check the following:

• Transmission fluid level
• Transmission fluid condition (burned, metal particles or discolored)
• Engine cooling system
• Other non-related transmission DTCs