LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transaxle/Transmission - AISIN Aw21) >> Diagnostic Tests >> Diagnosis By Symptom >> Diagnosis by Symptom Chart Directions

Diagnosis by Symptom Chart Directions

WARNING: This page is about a different variant/trim than selected.
  1. Using the Symptom Index, select the concern/symptom that best describes the condition.
  2. See the routine indicated in the diagnosis by Symptom Index.
  3. Always begin diagnosis of a symptom with:
    1. Preliminary inspections.
    2. Verifications of condition.
    3. Checking the fluid levels.
    4. Carry out other test procedures as directed.
  4. NOTE: Not all concerns and conditions with electrical components will set a DTC. Be aware that the components listed may still be the cause. Verify correct function of these components prior to proceeding to the routine listed.
  5. Begin with the routine indicated. Follow the reference or action required statements. Always carry out the on-board diagnostic tests as required. Never skip steps. Repair as required. These components are listed in the removal sequence and by the most probable cause. All components listed must be inspected to make sure of correct repair.
DIAGNOSIS BY SYMPTOM INDEX

Title Routines
Engagement Concerns 
No forward and/or No reverse 207
Harsh 208
Soft 209
Torque Converter Clutch Operation Concerns 
Does not apply 240
Cycling/shudder/chatters 242
NVH 
Noise/vibration - forward or reverse 254
Other Concerns 
Transmission fluid level 286
Transmission fluid condition 287
Transmission control module software 288