LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Rear Drive Axle/Differential) >> In-Vehicle Servicing >> Stub Shaft Seal >> Removal

Stub Shaft Seal: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: The rear drive unit (RDU) does not have stub shaft pilot bearings. It has stub shaft seals only.
  1. Remove the halfshaft assembly. For additional information, refer to REAR DRIVE HALFSHAFTS article.
  2. Using the special tools, remove the stub shaft seal.
    3. Fig 1: Removing Stub Shaft Seal Using Special Tools (307-309, 100-001)
    GF0024591Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals