LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Transfer Case - Power Transfer Unit (PTU)) >> In-Vehicle Servicing >> Cover Seal >> Installation

Cover Seal: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Assemble the Driver Handle, the Halfshaft Oil Seal Installer and the Shaft Bearing Cup Installer as shown.
    2. Fig 1: Assembling Driver Handle, Halfshaft Oil Seal Installer & Shaft Bearing Cup Installer
    GF0041489Courtesy of FORD MOTOR CO.
  2. Using the Driver Handle, the Halfshaft Oil Seal Installer and the Shaft Bearing Cup Installer, install the cover seal in the PTU.
    3. Fig 2: Installing Cover Seal In PTU
    GF0041490Courtesy of FORD MOTOR CO.
  3. Install the intermediate shaft seal and deflector. For additional information, refer to Intermediate Shaft Seal and Deflector .
  4. Fill the PTU fluid as necessary. For additional information, refer to Power Transfer Unit (PTU) Draining and Filling  in this section.
scientia non olet · About LEMON Manuals