LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Accessory Drive System - 3.0L (4V)) >> Removal And Installation >> Coolant Pump Belt >> Removal

Coolant Pump Belt: Removal

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Cut and remove the coolant pump belt.
    • Discard the belt.
  3. Fig 1: Locating Coolant Pump Belt
    GF0024332Courtesy of FORD MOTOR CO.