LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Accessory Drive System - 3.0L (4V)) >> Removal And Installation >> Coolant Pump Belt >> Installation

Coolant Pump Belt: Installation

WARNING: This page is about a different variant/trim than selected.
    NOTE: To install the coolant pump belt, remove the 2 splash shields for access to the crankshaft bolt.
  1. Remove the 4 screws and position the RH fender splash shield aside.
    2. Fig 1: Locating RH Fender Splash Shield Screws
    G04684102Courtesy of FORD MOTOR CO.
  2. Remove the 6 pin-type retainers and the RH splash shield.
    3. Fig 2: Locating Pin-Type Retainers On RH Splash Shield
    GF0041351Courtesy of FORD MOTOR CO.
  3. Install the coolant pump belt on the coolant pump pulley and position it on the camshaft pulley.
    4. Fig 3: Locating Coolant Pump Belt On Coolant Pump Pulley
    GF0024357Courtesy of FORD MOTOR CO.
    NOTE: Do not use any screwdrivers, pliers or other metal objects that could cause damage to the belt or camshaft pulley while installing the belt.
  4. Rotate the crankshaft clockwise to seat the coolant pump belt on the camshaft pulley.
  5. Install the RH splash shield and the 6 pin-type retainers.
    6. Fig 4: Locating Pin-Type Retainers On RH Splash Shield
    GF0041351Courtesy of FORD MOTOR CO.
  6. Position the RH fender splash shield and install the 4 screws.
    7. Fig 5: Locating RH Fender Splash Shield Screws
    G04684102Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals