LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Accessory Drive System - 3.0L (4V)) >> Removal And Installation >> Accessory Drive Belt >> Removal And Installation

Removal And Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the 4 screws and position the RH fender splash shield aside.
    3. Fig 1: Locating RH Fender Splash Shield Screws
    G04684102Courtesy of FORD MOTOR CO.
  3. Remove the 6 pin-type retainers and the RH splash shield.
  4. Using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals