LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Accessory Drive System - 3.0L (4V)) >> Removal And Installation >> Accessory Drive Belt Tensioner >> Removal And Installation

Removal And Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the 4 screws and position the RH fender splash shield aside.
    3. Fig 1: Locating RH Fender Splash Shield Screws
    G04684102Courtesy of FORD MOTOR CO.
  3. Remove the 6 pin-type retainers and the A/C splash shield.
  4. Using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner counterclockwise and position the accessory drive belt off of the accessory drive belt tensioner.
  5. Remove the bolt and the accessory drive belt tensioner.
    • To install, tighten to 45 Nm (33 lb-ft).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals