Crankshaft Pulley: Installation

WARNING: This page is about a different car, the 2008 Lincoln MKZ. However, it is still accessible from the selected car via links, so may be relevant.

Lubricate the crankshaft front seal inner lip with clean engine oil.

NOTE: Lubricate the outside diameter sealing surfaces with clean engine oil.

Using the Front Cover Oil Seal Installer and Crankshaft Vibration Damper Installer, install the crankshaft pulley.

Fig 1: Installing Crankshaft Pulley

Courtesy of FORD MOTOR CO.

Using the Strap Wrench, install the crankshaft pulley washer and new bolt and tighten in 4 stages.
- Stage 1: Tighten to 120 Nm (89 lb-ft).
- Stage 2: Loosen one full turn.
- Stage 3: Tighten to 50 Nm (37 lb-ft).
- Stage 4: Tighten an additional 90 degrees.

Fig 2: Installing Crankshaft Pulley Washer & Bolt Using Special Tools (303-D055)

Courtesy of FORD MOTOR CO.

Install the accessory drive belt and the power steering belt. For additional information, refer to ACCESSORY DRIVE - 3.5L article.