LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 976 (Accessory Drive) >> Removal And Installation >> Power Steering Pump Belt >> Installation

Power Steering Pump Belt: Installation

WARNING: This page is about a different car, the 2008 Lincoln MKZ. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power steering belt on the crankshaft pulley.
    2. NOTE: After installation, make sure the belt is correctly seated on the crankshaft and power steering pulleys.
  2. Position the power steering belt around the Power Steering Belt Installation Tool and the power steering pulley. Make sure the belt is engaged with the power steering pulley and rotate the crankshaft clockwise to install the power steering belt.
    3. Fig 1: Installing Power Steering Belt Onto Power Steering Pump Pulley Using Special Tool (303-1252/2)
    GF0029390Courtesy of FORD MOTOR CO.
  3. Position the accessory drive belt on the crankshaft pulley.
    4. NOTE: After installation, make sure the accessory drive belt is correctly seated on all pulleys.
  4. Working from the top of the vehicle, using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner clockwise and install the accessory drive belt on the generator pulley.
  5. Install the RH splash shield and the 6 pin-type retainers.
  6. Position the RH fender splash shield and install the 4 screws.
    7. Fig 2: Locating RH Fender Splash Shield Screws
    G04684102Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals