LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 976 (Accessory Drive) >> Removal And Installation >> Accessory Drive Belt Tensioner >> Removal

Accessory Drive Belt Tensioner: Removal

WARNING: This page is about a different car, the 2008 Lincoln MKZ. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Working from the top of the vehicle, using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the generator pulley.
  3. Remove the 4 screws and position the RH fender splash shield aside.
    4. Fig 1: Locating RH Fender Splash Shield Screws
    G04684102Courtesy of FORD MOTOR CO.
  4. Remove the 6 pin-type retainers and the RH splash shield.
  5. Remove the 3 bolts and the accessory drive belt tensioner.
scientia non olet · About LEMON Manuals