LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1887 (Engine Controls - Pinpoint Test DL: Cylinder Head Temperature (CHT) Sensor Through Pinpoint Test DY: Engine Oil Temperature (EOT) Sensor - (Except Diesel & Hybrid)) >> Pinpoint Test DU: Intake Air Temperature 2 (IAT2) Sensor >> Introduction

Pinpoint Test DU: Intake Air Temperature 2 (IAT2) Sensor: Introduction

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2009 Mercury Mountaineer, 2009 Mercury Milan, 2009 Mercury Mariner, 2009 Mercury Grand Marquis, and 2009 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

This pinpoint test is intended to diagnose the following:

Voltage values calculated for VREF = 5 volts. These values can vary by 15% due to sensor and VREF variations.

Fig 1: Temperature Sensor Voltage And Resistance Characteristic Graph
G06053965Courtesy of FORD MOTOR CO.
TEMPERATURE SENSOR VOLTAGE AND RESISTANCE SPECIFICATIONS

Temperature Temperature Sensor Values
°C °F Voltage Resistance (K ohms)
120 248 0.28 1.18
110 230 0.36 1.55
100 212 0.47 2.07
90 194 0.61 2.80
80 176 0.80 3.84
70 158 1.05 5.37
60 140 1.37 7.70
50 122 1.77 10.97
40 104 2.23 16.15
30 86 2.74 24.27
20 68 3.26 37.30
10 50 3.73 58.75
0 32 4.14 95.85
-10 14 4.45 160.31
Fig 2: Intake Air Temperature 2 (IAT2) Sensor Connector
G06053989Courtesy of FORD MOTOR CO.
POWERTRAIN CONTROL MODULE (PCM) CONNECTOR

Connector Pin Circuit
170 Pin B41, E58, T41
B40, E57
E27
SIGRTN
VREF
IAT2