Removal And Installation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the pin-type retainers and position the luggage compartment trim aside.
- Support the luggage compartment lid with a suitable support rod.
- Disconnect the luggage compartment lid motor assembly wiring harness electrical connector.
- Remove the luggage compartment lid motor assembly arm bolt from the luggage compartment lid hinge.
- To install, tighten to 9 Nm (80 lb-in).
- Loosen the luggage compartment lid motor assembly bolt.
- To install, tighten to 9 Nm (80 lb-in).
- Loosen the luggage compartment lid motor assembly lower bolt.
- To install, tighten to 9 Nm (80 lb-in).
- Remove the 2 bolts and the luggage compartment lid motor assembly.
- To install, tighten to 9 Nm (80 lb-in).
- If required, remove 3 bolts and the luggage compartment lid drive motor.
- Disconnect the electrical connector.
- To install, tighten to 7 Nm (62 lb-in).
- To install, reverse the removal procedure.
- Carry out the initialization procedure. For additional information, refer to Luggage Compartment Lid Motor Initialization .