LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1428 (Fuel System - General Information) >> Diagnosis And Testing >> Fuel System >> Pinpoint Test >> Pinpoint Test A: Slow to Fill >> Pinpoint Test A: Slow To Fill

Pinpoint Test A: Slow To Fill

WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. A1 CARRY OUT INSPECTION AND VERIFICATION 
    • Carry out inspection and verification.
    • Was the cause of the concern found? 
    1. YES  : REPAIR or INSTALL new components to correct the concern.
    2. NO  : Go to  A2.
  2. A2 CHECK THE SYSTEM FOR ANY EVAP DTCs 
    • Connect the scan tool.
    • Check the system for any of the following EVAP DTCs: P0446, P0451, P0452, P0453, P0454, P1443, P1450, P1451 and P260F.
    • Are any of these DTCs present? 
    1. YES  : REFER to INTRODUCTION - GASOLINE ENGINES article to diagnosis the EVAP system.
    2. NO  : Go to  A3.
  3. A3 MONITOR THE FUEL TANK PRESSURE (FTP) WHILE FILLING THE FUEL TANK 
    1. YES  : Go to  A5.
    2. NO  : Go to  A4.
  4. A4 MONITOR THE FTP WHILE FILLING THE FUEL TANK WITH THE EVAP SYSTEM DISCONNECTED 
    • Disconnect the fuel tank-to-EVAP canister quick connect coupling at the EVAP canister. Refer to QUICK CONNECT COUPLING .
    • Monitor the FTP reference value while filling the fuel tank. REFER to INTRODUCTION - GASOLINE ENGINES article.
    • Is FTP within specification? 
    1. YES  : INSPECT the EVAP system for blockage or restrictions. REPAIR the blockage or restriction. If the restriction or blockage cannot be repaired, INSTALL new EVAP system components.
    2. NO  : Go to  A5.
  5. A5 CHECK THE FUEL TANK FILLER PIPE ASSEMBLY FOR BLOCKAGE OR RESTRICTION 
    • Remove the fuel tank filler pipe assembly. REFER to FUEL TANK AND LINES article.
    • Inspect the fuel tank filler pipe and fuel tank filler pipe vent tube (if equipped) for a blockage or restriction.
    • Is the fuel tank filler pipe or fuel tank filler pipe vent tube (if equipped) blocked or restricted? 
    1. YES  : If possible, REPAIR the blockage or restriction. If the blockage or restriction cannot be repaired, INSTALL a new fuel tank filler pipe or fuel tank filler pipe vent tube.
    2. NO  : Go to  A6.
  6. A6 CHECK THE FUEL TANK INLET CHECK VALVE 
    • Inspect the fuel tank inlet check valve for restriction or sticking.
    • Is the fuel tank filler pipe inlet check valve restricted or sticking? 
    1. YES  : If possible, REPAIR the restriction. If the restriction cannot be repaired, INSTALL a new fuel tank. REFER to FUEL TANK AND LINES article.
    2. NO  : INSTALL a new fuel tank. REFER to FUEL TANK AND LINES article.
scientia non olet · About LEMON Manuals