LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1423 (Manual Transmission External Controls System) >> Removal And Installation >> Gearshift Lever >> Installation

Gearshift Lever: Installation

WARNING: This page is about a different car, the 2009 Mercury Milan and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the gearshift lever assembly in the vehicle.
  2. Install the 4 gearshift lever nuts.
    • Tighten to 23 Nm (17 lb-ft).
  3. Connect the selector cable.
  4. Connect the shift cable.
    • Tighten the nut to 9 Nm (80 lb-in).
  5. Adjust the gearshift cables. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION article.
  6. Position the console and install the 2 console screws to the shifter base.
  7. Install the 2 front console center bolts and then install the 2 rear side console bolts.
scientia non olet · About LEMON Manuals