Selector Lever Knob - 2.3L, 3.0L: Installation

WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Do not overtighten the selector lever knob bolts or damage to the selector lever or knob may occur.

Install the selector lever knob and 2 new bolts.
- Tighten to 2 Nm (18 lb-in).

Fig 1: Locating Bolts

Courtesy of FORD MOTOR CO.

Slide the lower selector lever knob bezel up and snap it into place.

Fig 2: Sliding Lower Shift Knob Bezel Up

Courtesy of FORD MOTOR CO.