Selector Lever Bezel: Removal

All vehicles 

1. Remove the PRNDL trim ring.
Fig 1: Locating PRNDL Trim Ring
Courtesy of FORD MOTOR CO.
2. Remove the upper console panel.
Fig 2: Locating Upper Console Panel
Courtesy of FORD MOTOR CO.

Fusion/Milan 

3. Remove the power outlet trim panel from the center console.
Fig 3: Locating Power Outlet Trim Panel
Courtesy of FORD MOTOR CO.
4. Disconnect the electrical connector and remove the power outlet trim panel.
Fig 4: Locating Power Outlet Electrical Connector
Courtesy of FORD MOTOR CO.

All vehicles 

5. Slide the lower selector lever knob bezel downward.
Fig 5: Sliding Lower Shift Knob Bezel Downward
Courtesy of FORD MOTOR CO.
6. Remove and discard the 2 bolts from the selector lever knob.
Fig 6: Locating Bolts
Courtesy of FORD MOTOR CO.

Vehicles equipped with a light bulb 

7. Disconnect the light from the PRNDL bezel.
Fig 7: Locating Light From PRNDL Bezel
Courtesy of FORD MOTOR CO.

Vehicles equipped with LED illumination 

8. Disconnect the LED electrical connector.
Fig 8: Locating LED Electrical Connector
Courtesy of FORD MOTOR CO.

Vehicles equipped with a Transmission Control Switch (TCS) 

9. Disconnect the Transmission Control Switch (TCS) electrical connector and remove the wiring harness fastener from the selector lever housing.
Fig 9: Locating Transmission Control (TC) Switch Electrical Connector
Courtesy of FORD MOTOR CO.

All vehicles 

NOTE: Selector lever removed for clarity.
10. Release the 3 tabs and remove the PRNDL bezel selector lever knob and knob bezel.
Fig 10: Locating Tabs
Courtesy of FORD MOTOR CO.