LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1417 (Parking Aid System) >> Diagnosis And Testing >> Parking Aid >> Symptom Chart

Symptom Chart

WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
Symptom Chart

Condition Possible Sources Action
  • No communication with the parking aid module (PAM)
  • Fuse
  • Wiring, terminals or connectors
  • PAM
  • The parking aid is inoperative/does not operate correctly
  • Wiring, terminals or connectors
  • Parking aid sensors alignment
  • PAM
  • Rear bumper cover
  • Continuous or intermittent tone when no obstacles or fault codes are present (certain obstacles may appear "stealthy" to the system, depending on geometric shape, size and material)
  • Dirty or iced over parking aid sensor(s)
  • CLEAN the rear bumper and sensors with high-pressure water.
  • Parking aid sensor bezel(s) or parking aid sensor(s) locked into the rear bumper cover incorrectly
  • Parking aid sensors are not aligned correctly
  • REMOVE and correctly INSTALL the parking aid sensor(s) and or bezel(s) as necessary. REFER to PARKING AID SENSOR .
  • Parking aid sensor(s)
  • PAM
  • The Audio Control Module (ACM) volume does not decrease when the transmission is selected to reverse and the reverse sensing system is enabled
  • Wiring, terminals or connectors
  • PAM
  • ACM