LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1410 (Automatic Transmission - FNR5) >> In-Vehicle Servicing >> Turbine Shaft Speed (TSS) Sensor >> Removal

Turbine Shaft Speed (TSS) Sensor: Removal

WARNING: This page is about a different car, the 2009 Mercury Milan and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the Turbine Shaft Speed (TSS) sensor electrical connector.
    2. Fig 1: Locating Turbine Shaft Speed (TSS) Sensor Electrical Connector
    GF0029799Courtesy of FORD MOTOR CO.
  2. Remove the bolt and the TSS sensor.
    • To install, tighten to 10 Nm (89 lb-in).
    • Check the TSS sensor bore.
    • Check the O-ring seal for nicks or cuts and install a new O-ring if necessary.
    3. Fig 2: Locating TSS Sensor Bolt
    GF0029800Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals