Transmission Fluid Pan: Removal

WARNING: This page is about a different car, the 2009 Mercury Milan and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Remove the drain plug and allow the transmission fluid to drain.

Fig 1: Locating Transmission Fluid Pan Drain Plug

Courtesy of FORD MOTOR CO.

Install the drain plug.
- Tighten to 29 Nm (21 lb-ft).

Fig 2: Locating Transmission Fluid Pan Drain Plug

Courtesy of FORD MOTOR CO.

Remove the transmission fluid pan.
- Remove the bolts.
- Using a suitable tool, separate the bead of sealer.

Fig 3: Identifying Transaxle Fluid Pan Bolts

Courtesy of FORD MOTOR CO.

Clean the silicone from the transmission fluid pan and transaxle case surfaces thoroughly with metal surface cleaner.