LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1410 (Automatic Transmission - FNR5) >> In-Vehicle Servicing >> Output Shaft Speed (OSS) Sensor >> Installation

Output Shaft Speed (OSS) Sensor: Installation

WARNING: This page is about a different car, the 2009 Mercury Milan and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Apply a light coat of petroleum jelly to the O-ring before installation.
  1. Install the OSS sensor.
    • Tighten the OSS sensor bolt to 10 Nm (89 lb-in).
    • Connect the OSS electrical connector.
    2. Fig 1: Locating OSS Sensor
    GF0029804Courtesy of FORD MOTOR CO.
  2. Check the transmission fluid level and add transmission fluid as necessary.
    3. Fig 2: Locating Transmission Fluid Level
    GF0029805Courtesy of FORD MOTOR CO.
  3. Start the engine and move the selector lever through all gear positions.
scientia non olet · About LEMON Manuals