LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1410 (Automatic Transmission - FNR5) >> In-Vehicle Servicing >> Intermediate Shaft Speed Sensor >> Removal

Intermediate Shaft Speed Sensor: Removal

WARNING: This page is about a different car, the 2009 Mercury Milan and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the intermediate shaft speed sensor electrical connector.
    2. Fig 1: Locating Intermediate Shaft Speed Sensor Electrical Connector
    GF0029796Courtesy of FORD MOTOR CO.
  2. Remove the bolt and the intermediate shaft speed sensor.
    • To install, tighten to 10 Nm (89 lb-in).
    • Check the sensor bore.
    • Check the O-ring seal for nicks or cuts and install a new O-ring if necessary.
    3. Fig 2: Locating Intermediate Shaft Speed Sensor Bolt
    GF0029797Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals