LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1410 (Automatic Transmission - FNR5) >> In-Vehicle Servicing >> Halfshaft Seal - RH >> Installation

Halfshaft Seal - RH: Installation

WARNING: This page is about a different car, the 2009 Mercury Milan and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the new differential fluid seal on the Output Shaft Seal Installer and Handle.
    2. Fig 1: Identifying Special Tools (205-153, 307-572) And Differential Fluid Seal
    GF0029808Courtesy of FORD MOTOR CO.
  2. Using the Output Shaft Seal Installer and Handle, install the halfshaft seal.
    3. Fig 2: Identifying Special Tool (205-153, 307-572) And Halfshaft Seal
    GF0029810Courtesy of FORD MOTOR CO.
  3. Install the RH halfshaft. For additional information, refer to FRONT DRIVE HALFSHAFTS article.
scientia non olet · About LEMON Manuals