LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1409 (Automatic Transmission - AISIN Aw21) >> Disassembly And Assembly Of Subassemblies >> Torque Converter Hub Seal >> Disassembly

Torque Converter Hub Seal: Disassembly

WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transaxle. For additional information, refer to Transaxle - 3.0L  or Transaxle - 3.5L .
  2. Remove the torque converter.
  3. Using the Input Shaft Oil Seal Remover and Slide Hammer, remove the torque converter hub seal.
    4. Fig 1: Removing Torque Converter Hub Seal
    GF0017795Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals