LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1409 (Automatic Transmission - AISIN Aw21) >> Diagnostic Tests >> Leakage Inspection >> Notes

Leakage Inspection: Notes

WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools

Illustration Tool Name Tool Number
GF0000174Courtesy of FORD MOTOR CO.
100W/12 Volt DC UV Lamp 164-R0751
Material

Item Specification
Dye-Lite® ATF/Power Steering Fluid Leak Detection Dye
164-R3701 (Rotunda)
-
Motorcraft Premium Automatic Transmission Fluid
XT-8-QAW (US); CXT-8-LAW12 (Canada)
WSS-M2C924-A
NOTE: Do not try to stop the fluid leak by increasing the torque beyond specifications. This may cause damage to the case threads.

Use the following chart to inspect and correct any external transmission fluid leaks.

EXTERNAL TRANSMISSION FLUID LEAKS

Description Action
Leaks at the transmission fluid pan to case Tighten to specification or install a new transmission fluid gasket.
Transmission fluid filler plug leaks Install a new transmission fluid filler plug.
Transmission fluid cooler or fittings leaking Tighten to specification or install new transmission fluid cooler tubes. Refer to TRANSAXLE/TRANSMISSION COOLING article.
Transmission fluid cooler nut to case fitting leaking Inspect for damage or missing O-ring seals. Tighten to specification, install new transmission fluid cooler tubes or install new O-rings. Refer to TRANSAXLE/TRANSMISSION COOLING article.
Leaks at the transmission fluid cooler Inspect the transmission fluid cooler for damage, if damaged, install a new transmission fluid cooler. Refer to TRANSAXLE/TRANSMISSION COOLING article.
Leaks at the manual control lever seal Install a new manual control lever seal.
Leaks at the solenoid body harness connector Install a new solenoid body harness connector O-ring seal, either on the harness end or the solenoid body.