Normal Operation

WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

As part of the supplemental restraint system (SRS), the driver seat is equipped with a seat track position sensor. The seat track position sensor is comprised of integrated circuits called Hall-effect switch. The seat track position sensor indicates to the restraints control module (RCM) the position of the driver seat, forward or rearward.

The RCM supplies current to the seat track position sensor. Current flows through the switch, both in the forward or rearward seat position to ground. The RCM will sense the difference in this current draw, 6 mA (forward) or 15 mA (rearward), and use this information in determining the deployment rate of the dual-stage driver air bag module. If the RCM detects current out of range, it will set a DTC.

If the RCM detects a short to ground, it will store DTC C1947 in memory and send a message to the instrument cluster (IC) module to illuminate the air bag warning indicator.

DTC C1947 Front Driver's Seat Track Position Switch Circuit Short to Ground - If the RCM detects a short to ground on the driver seat track position sensor circuit, it will set this DTC.

This pinpoint test is intended to diagnose the following:

Wiring, terminals or connectors
Driver seat track position sensor
RCM