LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1395 (HVAC Climate Control System) >> Removal And Installation >> Clutch and Clutch Field Coil >> Removal

Clutch and Clutch Field Coil: Removal

WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the A/C compressor. For additional information, refer to AIR CONDITIONING (A/C) COMPRESSOR - 2.3L  or AIR CONDITIONING (A/C) COMPRESSOR - 3.0L, 3.5L .
  2. Remove the 3 screws and the A/C clutch shield (if equipped).
    3. Fig 1: Locating A/C Clutch Shield Screw
    GF0030335Courtesy of FORD MOTOR CO.
  3. Remove the A/C clutch disc and hub bolt.
    1. Hold the A/C clutch disc and hub with the special tool.
    2. Remove the A/C clutch disc and hub bolt.
    4. Fig 2: Holding A/C Clutch Disc & Hub With Special Tool (412-134)
    GF0004394Courtesy of FORD MOTOR CO.
  4. Remove the A/C clutch disc and hub.
  5. Remove the A/C compressor pulley snap ring.
  6. Remove the A/C compressor pulley.
  7. Remove the A/C clutch field coil electrical connector clip screw.
    8. Fig 3: Locating A/C Clutch Field Coil Electrical Connector Clip Screw
    GF0030336Courtesy of FORD MOTOR CO.
  8. Remove the A/C clutch field coil snap ring.
  9. Remove the A/C clutch field coil.
scientia non olet · About LEMON Manuals