Seat Cushion Cover - Rear

WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear seat cushion. For additional information, refer to Seat Cushion - Rear .
Release the drawstring and remove the hog rings.

Fig 1: Locating Hog Rings

Courtesy of FORD MOTOR CO.

CAUTION: Use care when separating the backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the backrest foam pad.

Partially invert the trim cover and release the hook-and-loop strips up to the hog rings.
Remove the hog rings and continue to release the hook-and-loop strips and separate the trim cover from the foam pad.

Fig 2: Locating Hog Rings And Loop Strips

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.
Install the rear seat cushion. For additional information, refer to Seat Cushion - Rear .