LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1394 (Seat System - Seating) >> Removal And Installation >> Seat Bolster - Rear >> Installation

Seat Bolster - Rear: Installation

WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the side bolster, align and insert to the latch.
  2. Align the bolt holes and install the side bolster bolt.
    • Tighten to 11 Nm (8 lb-ft).
  3. Install the rear seat cushion. Refer to Seat Cushion - Rear .
    • Make sure the safety belts and buckles are accessible to the occupants after installation.
scientia non olet · About LEMON Manuals