LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1394 (Seat System - Seating) >> Removal And Installation >> Seat Backrest Latch - Rear >> Removal

Seat Backrest Latch - Rear: Removal

WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: LH side shown, RH side similar.
  1. Remove the parcel shelf from the rear of the vehicle to access the rear backrest latch nuts. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
    2. NOTE: Make sure the affected backrest is released.
  2. Access the luggage compartment, detach the trim pin-type retainer and position the trim aside.
  3. Remove the 2 nuts and detach the latch release handle bracket.
  4. Detach the 2 pin-type retainers and latch cable assembly.
    • Note the cable routing for installation.
  5. Detach the release cable from the latch and remove.
  6. Remove the backrest latch.
    • Remove the 2 nuts and backrest latch.
scientia non olet · About LEMON Manuals