LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1394 (Seat System - Seating) >> Removal And Installation >> Seat Backrest - Rear >> Removal

Seat Backrest - Rear: Removal

WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: LH side shown, RH side similar.
  1. Remove the rear seat cushion. For additional information, refer to Seat Cushion - Rear .
  2. Remove the 2 forward backrest-to-floor bolts from the affected rear backrest assembly.
    3. NOTE: If the center safety belt retractor locks and the safety belt webbing prevents the backrest from lowering, raise the backrest upward to release the safety belt retractor and belt webbing.
  3. Release the backrest latch in the luggage compartment area and position the backrest downward.
  4. Position aside the floor trim cover behind the backrest to gain access to the rearward backrest-to-floor bolts and remove the 2 bolts.
  5. Raise the rear seat backrest and hinge assembly upward from the 2 locator pins on the floor and remove the backrest.
scientia non olet · About LEMON Manuals