Dual Climate Controlled Seat Module (DCSM): Removal
WARNING: This page is about a different car, the 2009 Mercury Milan, 2009 Lincoln MKZ, and 2009 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The air bag warning lamp illuminates when the correct restraints control module (RCM) fuse is removed and the ignition switch is ON.
NOTE:
When installing a new dual climate controlled seat module (DCSM), it is necessary to carry out programmable module installation (PMI). For additional information, refer to MODULE CONFIGURATION
article.
NOTE:
The supplemental restraint system (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
- Before removing the DCSM, carry out the appropriate steps in the PMI procedure. For additional information, refer to MODULE CONFIGURATION article.
- Remove the front passenger seat. For additional information, refer to Seat - Front .
- Remove the DCSM from the cushion electrical bracket.
- Release the locking wedges and disconnect the 3 DCSM electrical connectors.
- Remove the 2 rivets and DCSM.